What are the effects of the long-term operation and wear of the conductive slip ring?

What are the effects of the long-term operation and wear of the conductive slip ring?

Here we would like to share with you the impact of the wear of the conductive slip ring used for a long time:

Compared with many technical personnel know, the motor sliding ring running time is too long, due to wear and other reasons will cause the collector ring on the bond groove grinding width and bond wear, so that the shaft and the collector ring gap is too large and cause vibration. At this time, it is necessary to remove the motor collector ring, reopen the key groove, and replace it with the scale groove. If the inner diameter is severely worn, the motor power collector ring should be replaced. When the collector ring of the motor vibrate slightly, it should be handled in time to avoid expanding the situation.

In the replacement of the motor slip ring is not installed in place, so that the contact area with the motor shaft is reduced or because of the assembly is too loose and cause vibration, will cause problems. Before the assembly, the size should be checked first, and the fit should be selected by using the base axis system. Avoid the improper choice of coordination tolerance is too tight or too loose phenomenon. Be sure to pay strict attention to the above tips.

Please contact us at whatsapp:13302489809 if you need any help.