How to improve the overall processing technology of the conductive slip ring products

How to improve the overall processing technology of the conductive slip ring products

Today brings you how to improve the overall processing process of conductive slip ring products, specifically as follows:

For different types of ring, processing technology is different, quality requirements of different ring, processing technology is also different, so different processing process may lead to what kind of problems between first to super refined, mainly refers to the good lubrication conditions, the workpiece rotate at a certain speed, at the same time with fine-grained stone with a certain pressure to the workpiece processing surface and in the perpendicular to the workpiece rotation direction for reciprocating movement of a processing method. This method can effectively reduce the ripple degree. In the process of superfine research, when the arc between the millstone and the conductive ring workpiece is greater than or equal to the wavelength of the surface ripple of the workpiece, it can ensure that the millstone will always act on the peak without contact with the trough. Therefore, the contact pressure of the peak is large, and the convex peak is removed, thus reducing the ripple.

Can increase the contact area of the working surface of the conductive ring. After super grinding, the contact support area of the working surface can be greatly increased after grinding.

Conductive slip ring processing process is bad, usually easy to lock or bite often occurs on the sliding ring end cover, aluminum alloy and titanium alloy material, the metal alloy itself has corrosion resistance, when the conductive ring fasteners are locked, tooth pressure and heat will destroy the oxide layer, make the metal thread between blocking or shear, and then the phenomenon of adhesion.

When a surface is damaged, a thin oxide layer is created on the metal surface to prevent it. And the speed force into the spin should be appropriate, not too fast too large, as far as possible to choose torque wrench or sleeve wrench, avoid the use of active wrench or electric wrench. Too fast will make the temperature rise rapidly and lock up.